INFUSION MAIN POWER ENCLOSURE 2 MODULE 24V

INFUSION MAIN ENCLOSURES - 24 VOLT

InFusion Main Power Enclosure 2 module 24V

Enlarge Photo

INFUSION MAIN POWER ENCLOSURE 2 MODULE 24V

 

Part #: IMPE-2-IC24 

 

Vantage's InFusion Main Power Enclosure is a key component of Vantage's lighting control centralized solution. This Main Power Enclosure houses the InFusion Controller and up to two separate control modules.

The InFusion control modules that mount in the enclosure include standard, electronic and low voltage dimming and relay control. Each enclosure features new module locking mechanisms for improved in-field plug and play installation and service; allowing modules to be quickly replaced without affecting load connections to the system.

Available in two or four module configurations layout of the IMPE is simply designed through Vantage Design Center Software. The enclosure is backward compatible with installed Q and InFusion Systems and forward compatible with Vantage's enhanced modules. This two module enclosure has the capacity for 16 line feeds and up to 256 amps. Designed for efficient field installation, the enclosure is easily mounted between 16” o.c. studs. Electrical compatibility includes 120 - 277 VAC and 50 or 60 Hz. It has a custom fitted hinged door for recessed or surface installs to give installers easier access to the controllers and modules.

Resources

 Cut Sheet
 INSTALL GUIDE

 

Je li Vam ovaj odgovor pomogao?

 Ispiši članak

Također pročitajte

24 VOLT INFUSION RACK MOUNT ENCLOSURE

RACK MOUNT/SURFACE MOUNT ENCLOSURES - 24 VOLT 24 VOLT INFUSION RACK MOUNT ENCLOSURE...

INFUSION MAIN POWER ENCLOSURE 4 MODULE 24V

INFUSION MAIN ENCLOSURES - 24 VOLT INFUSION MAIN POWER ENCLOSURE 4 MODULE 24V...

24 VOLT INFUSION SURFACE MOUNT ENCLOSURE

RACK MOUNT/SURFACE MOUNT ENCLOSURES - 24 VOLT 24 VOLT INFUSION SURFACE MOUNT...

Powered by WHMCompleteSolution